Machine Vision Sensor Enclosures
(Stock Items)
PVS-30-ENC1 Sensor Enclosure
Phoenix Imaging manufactures several different types of sensor enclosures to
fit our most popular cameras. The PVS-20 & PVS-30 sensor enclosures
are completely sealed with the sensor cable protruding a tight hole out the rear
center of the enclosure. The PVS-20 & PVS-30 sensor enclosures are
available in either standard or long length models. The housing is
constructed of three pieces of solid aluminum precision machined and finished in
a black anodize coating. Butyl seals close all openings to the
housing. A 2" diameter borosilicate glass window protects the front
of the optics. The window is very tough and can be cleaned using standard
window cleaner and paper towel. The housing has 2) ¼-20 UNC mounting
holes on two sides and the bottom of the enclosure for mounting.
CVM-50-ENC1 & CVM-50-ENC2 sensor enclosures
These camera enclosure are very similar to the PVS-20 & PVS-30 enclosure
in terms of sensor mounting and lens sizes supported. However, the rear of
the sensor is exposed through the back of the housing. This allow access
to the switches, BNC and Hirose multi-pin connector(s). The sensor is not
fully enclosed in the housing and therefore should not be used in damp areas or
locations with extreme operating conditions.
CVM-A-ENC1 & CVM-A-ENC2 sensor enclosures
These camera enclosure are similar to the CVM-50-ENC1 & CVM-50-ENC2
enclosure in terms of sensor mounting and lens sizes supported. This
family of enclosures is designed for house the JAI "A" series sensors,
including the models A-50, A-60 & A-11.
The rear of the sensor is exposed through the back of the housing. This
allow access to the Hirose multi-pin connector(s). The sensor is not fully
enclosed in the housing and therefore should not be used in damp areas or
locations with extreme operating conditions.
CVM-130-ENC1 sensor enclosure
These camera enclosure are similar to the CVM-50-ENC1 enclosure in terms of
sensor mounting and lens sizes supported. This family of enclosures is
designed for house the Panasonic CF-130 series sensors.
The rear of the sensor is exposed through the back of the housing. This
allow access to the switches, BNC and Hirose multi-pin connector(s). The
sensor is not fully enclosed in the housing and therefore should not be used in
damp areas or locations with extreme operating conditions.
Other enclosure are added on a regular basis. If you have a special
request for a particular sensor please contact the plant for cost and delivery.
| 
